China Laminated Glass Manufacturers Sharing Info: Installation of EVA Vacuum Glass Laminating Machine

11/23/2010

Installation of EVA Vacuum Glass Laminating Machine | China Ucolin Inc.

nstallation of EVA Vacuum Glass Laminating Machine ：

⒈Vacuum Glass Laminating Machine Install control box：

⑴the control box must be carried by 2 people,use 4 nuts to fix it in the specified location.

Attention：Vacuum pump is different from blower.

⑵Electric Control box connection：connect according the signs at wire connecting

① and wire connecting②

+Wire connecting①

+Wire connecting②

+Power connecting

⒉Vacuum Glass Laminating Machine Vacuum pump installation：connect one side of above ￠9mX18m vacuum pipe to the vacuum pipe faucet on the table, another side is connected to the vacuum pump air pump faucet (as picture below)

⒊Vacuum Glass Laminating Machine Orbit installation: adjust the two orbits’ height, make it balance to the inside orbit of the machine, then put the up down car onto the orbit, adjust the width of the orbit; weld the outside orbit and inside orbit connecting to make it fixedness. Fix the outside orbit to the floor with screw (as picture below)

4.Vacuum Glass Laminating Machine Lift installation: waggle the lift toward the “hour hand” direction, lift going up, waggle the lift backward “hour hand” direction, lift going down.

+Vacuum Glass Laminating Machine Machine carry: as picture below